• 測量方法: TDM方法（脈沖寬度調制）

• 測量輸入: 電流：1 或 5 A；電壓 ：100至690 V

• 頻率: 50 Hz

• 測量范圍: 0 至 2 kVar

• 測量輸出: 單極或雙極

• 導軌安裝，外殼

• P13/70   相-相交流電流

• P18/105  三相電流

Combine E950-Qxx transducer converts to active or reactive power of a single phase or three phase system with balanced or unbalanced loads. The output signal is proportional to the measured value of the active or reactive power and is either a load independent DC current or load independent DC voltage.

		Negligible effect of Power factor variation on accuracym
		Narrow housing 70 mm. Saves space & therefore costs.
		Measuring inputs: Sine or distorted wave forms of nominal input currents & nominal input voltages. Input distortion up to 10%.
		Measuring principle: Time-division-multiplication (pulse duration modulation)
		Ripple in out put current: < = 1% p.p.
		Response time < 300 mS.
		Nominal input voltage 110/v3, 110, 230, 400V.
		Nominal input current: 1 or 5 A
		Power consumption: <0.1VA per current path, V x 1mA per voltage path.
		Output: DC current 0-1/0-5/0-10/ 0-20mA or 4..20mA. Load Resistance max. 750 Ohms for 20mA.
		Power supply: ac voltage 24…230 or 240V +/-15%, 42 to 70Hz. Power consumption 5VA.
		dc voltage 24… 90 or 90…240V. Power consumption 5W
		Power transducers with 3 phase 3/4 wire, balanced/unbalanced, active/ reactive.